Richard Ward

Wed 15 Jan 2014 09:27pm

Hi Brenda. The only way is to sand it right back. Either by hand or with an electric sander. Just remember to sand in the direction of the grain NEVER across it. Then once you've sanded It all back wipe down With white spirit, let it dry and then you're ready To stain and varnish. Hope this helps! All the best. Richard.

Was this helpful?

george goodall

Wed 15 Jan 2014 02:59pm

Hi Brenda, the best way would be to use an electric sander to remove the oil, that's the easiest way, but if not then its elbo grease im afraid to rub it down by hand, then when its clean from dust your ready to apply what you want. Good luck, George.

Was this helpful?