1. Testing Room
- Open new doorway into testing room from warehouse area (through stud wall).
- Remove stud wall and both doors between testing room and corridor to Operations area.
- Reuse one door for new doorway to warehouse (keep second door for future use).
- Replace floorboard by new doorway.
- Install LED emergency light fitting bulkhead above / adjacent to new door to testing room (warehouse side). Install a second emergency light in testing room leading to Ops area.
- Insert sliding window into partition wall [type and dimensions to be discussed].
- Make good crack in ceiling and paint testing room walls & ceiling.
2. Toilet & Kitchenette in Despatch Area
- Repair damaged wall [joists to be replaced by Jonny – waiting to see if the roof is now water-tight]
- Repair mortar and paint walls and pipework
- Repair / replace valve in toilet cistern
- Replace toilet seat
- Remove old towel dispenser, install mirror and new hand towel dispenser in sink area of toilet
- Check hot & cold water supply working OK
3. Fire Door & entrance and stairway to 1st floor
- Strip and repaint door and frame – inside and outside.
- Install handle to exterior and finger plate to interior of door
- Paint walls and window frame in lobby, stairway to 1st floor and 1st floor corridor leading to large office.
4. Large office, 1st floor
- Repair wall at roof supports
- Fill holes in end wall and paint
- Paint walls
- Sand water damaged floorboards and varnish
